Regulation No 4 of the Economic Commission for Europe of the United Nations (... (42009X0131(02))
INHALT
Regulation No 4 of the Economic Commission for Europe of the United Nations (UN/ECE) — Uniform provisions concerning the approval of devices for the illumination of rear registration plates of power-driven vehicles and their trailers
- Only the original UN/ECE texts have legal effect under international public law. The status and date of entry into force of this Regulation should be checked in the latest version of the UN/ECE status document TRANS/WP.29/343, available at: http://www.unece.org/trans/main/wp29/wp29wgs/wp29gen/wp29fdocstts.html
- Regulation No 4 of the Economic Commission for Europe of the United Nations (UN/ECE) — Uniform provisions concerning the approval of devices for the illumination of rear registration plates of power-driven vehicles and their trailers
- Revision 2 — Amendment 3
- 0. SCOPE
- 1. DEFINITIONS
- 2. APPLICATION FOR APPROVAL
- 3. MARKINGS
- 4. APPROVAL
- 5. GENERAL SPECIFICATIONS
- 6. COLOUR OF LIGHT
- 7. INCIDENCE OF THE LIGHT
- 8. MEASURING PROCEDURE
- 9. PHOTOMETRIC CHARACTERISTICS
- 10. CONFORMITY OF PRODUCTION
- 11. PENALTIES FOR NON-CONFORMITY OF PRODUCTION
- 12. PRODUCTION DEFINITELY DISCONTINUED
- 13. TRANSITIONAL PROVISIONS
- 14. NAMES AND ADDRESSES OF TECHNICAL SERVICES CONDUCTING APPROVAL TESTS, AND OF ADMINISTRATIVE DEPARTMENTS
- ANNEX 1
- ARRANGEMENT OF APPROVAL MARKS
- Figure 1
- Marking for single lamps
- MODEL A
- Figure 2
- Simplified marking for grouped, combined or reciprocally incorporated lamps
- (The vertical and horizontal lines schematise the shape of the light-signalling device. These are not part of the approval mark)
- Figure 3
- Light source modules
- MODEL E
- ANNEX 2
- ANNEX 3
- MEASUREMENT POINTS FOR TEST PURPOSES
- ANNEX 4
- MINIMUM FIELD OF VISIBILITY OF THE SURFACE TO BE ILLUMINATED
- ANNEX 5
- PHOTOMETRIC MEASUREMENT OF LAMPS EQUIPPED WITH SEVERAL LIGHT SOURCES
- ANNEX 6
- MINIMUM REQUIREMENTS FOR CONFORMITY OF PRODUCTION CONTROL PROCEDURES
- 1. GENERAL
- 2. MINIMUM REQUIREMENTS FOR VERIFICATION OF CONFORMITY BY THE MANUFACTURER
- 2.1. Nature of tests
- 2.2. Methods used in tests
- 2.3. Nature of sampling
- 2.4. Measured and recorded photometric characteristics
- 2.5. Criteria governing acceptability
- ANNEX 7
- MINIMUM REQUIREMENTS FOR SAMPLING BY AN INSPECTOR
- 1. GENERAL
- 2. FIRST SAMPLING
- 2.1. The conformity is not contested
- 2.2. The conformity is contested
- 2.3. Approval withdrawn
- 3. REPEATED SAMPLING
- 3.1. The conformity is not contested
- 3.2. The conformity is contested
- 3.3. Approval withdrawn
- Figure 1
Feedback