Commission Regulation (EC) No 517/2008 of 10 June 2008 laying down detailed rules... (32008R0517)
Commission Regulation (EC) No 517/2008 of 10 June 2008 laying down detailed rules for the implementation of Council Regulation (EC) No 850/98 as regards the determination of the mesh size and assessing the thickness of twine of fishing nets
- COMMISSION REGULATION
- (EC) No 517/2008
- of 10 June 2008
- laying down detailed rules for the implementation of Council Regulation (EC) No 850/98 as regards the determination of the mesh size and assessing the thickness of twine of fishing nets
- CHAPTER I
- SUBJECT MATTER AND DEFINITIONS
- Article 1
- Subject matter
- Article 2
- Definitions
- CHAPTER II
- EC GAUGES
- Article 3
- Mesh gauge and twine thickness gauges
- Article 4
- Calibration instruments for the mesh gauge
- Article 5
- Testing of the mesh gauges
- CHAPTER III
- DETERMINATION OF MESH SIZE
- Article 6
- Selection of meshes in active gear
- Article 7
- Selection of meshes in passive gear
- Article 8
- General provisions on the preparation and operation of mesh gauges
- Article 9
- Operation of the mesh gauge for measuring diamond and T90 meshes
- Article 10
- Operation of the mesh gauge for measuring square meshes
- Article 11
- Measurement conditions
- Article 12
- Measurement of the size of each selected mesh
- Article 13
- Determination of the mesh size of the net
- Article 14
- Determination of the mesh size in case of disputes
- CHAPTER IV
- ASSESSING TWINE THICKNESS
- Article 15
- General provisions on the selection of twines
- Article 16
- Selection of twines in diamond mesh netting
- Article 17
- Selection of twines in square mesh netting
- Article 18
- Selection of the twine thickness gauge
- Article 19
- Assessment conditions
- Article 20
- Assessment of the thickness of each selected twine
- Article 21
- Assessing twine thickness
- Article 22
- Assessment of twine thickness in case of disputes
- CHAPTER V
- FINAL PROVISIONS
- Article 23
- Repeal
- Article 24
- Transitional provisions
- Article 25
- Entry into force
- ANNEX I
- Mesh size and N-direction and T-direction of netting twine
- Figure
- ANNEX II
- Diamond knotted netting and T90 netting
- Figure 1
- Longitudinal axis of the net
- Figure 2
- ANNEX III
- Technical specifications of the mesh gauge
- Figure
- (These drawings are for illustrative purposes only)
- Appendix to Annex III
- Measurement algorithm
- ANNEX IV
- Technical specifications of the twine thickness gauge
- Figure
- Twine-measuring pliers assembly
- ANNEX V
- Calibration and testing of the mesh gauge
- A. Verification of length measurement
- Figure 1
- B. Verification of force measurement
- Figure 2
- (This drawing is for illustrative purposes only)
- ANNEX VI
- Preparation of the mesh gauge
- ANNEX VII
- Operation of the mesh gauge for inspection
- Figure
- ANNEX VIII
- Twines in diamond and square mesh netting
- Figure
- ANNEX IX
Feedback